I did the seat pan with PolyFiber. Then applied PolyBrush. I’m not sure if the PolyBrush was really required in this situation, but I read that some people wish they had done it. So, I did.
I ordered the Confor Foam from Hi-Tech Foams. I met the at Copperstate earlier in the year. They were extremely helpful and helped me order exactly what I needed with cutting guides.
I attached the foam to the seat and to each other with 3M upholstery glue. Then used a turkey carver to cut the foam. The foam cuts much better when it’s cold. Luckily, Arizona was abnormally cold during these days!
Here are my little carvers showing their supposed strength and threatening to do some “additional” carving!
They turned out very nice. I’m very pleased so far!