Landing Light Fiberglass

Here’s the end product!  I attended a two day fiberglass class that the EAA put on.  It was great and taught me the skills necessary to pull this off.

 

I created a fiberglass cylinder that attached to the light mount then roughly installed it in the hole I cut.

I built up the microspheres around the mount so I could fiberglass it in.  I don’t have a picture of what it looked like after the fiberglass on the back, but I made sure it wasn’t going to move!  🙂

Microspheres on the front, then logs of sanding to make it all smooth.

I sprayed on a sandable primer with UV protection.

Turned out pretty good!